Na samym poczatku prosze o modów o nie zamykanie tematu, jezeli taki juz był to sorry...
Zacznijmy od tego, ze sie za bardzo na tym nie znam, dlatego tutaj załozyłem ten topic z nadzieje, ze mi pomozecie...
Mam nagrywarke LG 24 10 40, ostatnio zmieniłem system na XP i wydawał sie , ze wszystko jest dobrze...
Nagrywałem juz Clonem, robiłem obraz plyty i wszystko było ok. Gdy probowałem uzyc Nero ( lub innego programu) do nagrania plyty audio to prz 3, 4 a czasem 5 % sie zatrzymywało tzn plyta cały czas sie kreciła w napedzie, zeden bład nie wyskakiwał, czekałem tak 20 min... i nic, zmarnowałem juz chyba z 6 plyt
. Ostanio uzyłem prgramu feurio... i to mi podczas nagrywania ( a raczej symulacji) wyskoczyło:
Error during Simulation of CD-recording:
There was an error when writing the leadin:
CD-Name: Various - New Project
Device: D: [1, 0, 0] HL-DT-ST - CD-RW GCE-8240B
Error: SCSI/IDE-bus reset
At command: Write Leadin
Comments/Hints: A SCSI/IDE-bus reset command was sended.
Possible causes:
- other devices at SCSI/IDE-bus / wrong cabling
A SCSI/IDE-bus-reset can also be produced by "big" communikation-errors on the SCSI/IDE-bus. E.g. this can be caused by a wrong cabling or devices at the bus that don't work correctly. Please check the SCSI/IDE-cabling; for SCSI: Test the termination! Remove temporarily not needed devices from the bus (e.g. Scanner, ZIP-device, other CD-ROMs) and test burning with a "minimal" setting!
- old/defective ASPI-driver
Often this error is caused by an old or defective ASPI-driver. Please call the "System diagnosis" at "Extras".
- defective drivers
Often this error is produced by defective drivers of other programs. Please call the"System diagnosis" at "Extras" and deactivate the drivers that will be detected as problematic by this diagnosis.
Remark for users of Windows 95/98:
This error can also occur when "Disconnection" has been deactivated for the particular device.
Explanation:
With "Disconnection" aktivated the device will be disconnected from the bus while working on a command. Without "Disconnection" the device will lock the bus the whole time while working on a command.
Under certain circumstances (e.g. when writing the leadin) the writer needs some time. In this case, some drivers or controllers "think" that the writer is crashed (since no reply for x seconds) and do a bus-reset.
Activation of "Disconnection":
- start the control panel (My Computer -> Control Panel).
- there start system
- select the property sheet "Device manager", expand the tree at CD-Rom, select the writer/CD-Rom, call "Properties", select the property sheet "Settings" and aktivate "Disconnection" (so while doing this you can also activate "DMA").
- restart computer
ErrCode: 18/-1/-1/67/fffffd02/629/0
Moze dla was to jest oczywiste, ale dla mnie niestety nie... wiec prosze was bardzo o pomoc